无溶剂环氧酚醛涂料的用途和使用注意事项模板.doc

资料内容仅供您学习参考，如有不当或者侵权，请联系改正或者删除。
无溶剂环氧酚醛涂料的用途和使用注意事项
Intended Uses
用途
不含挥发性有机溶剂, 固体份达100%, 室温固化5-45℃漆膜附着力强, 机械性能优, 易施工。
漆膜具有优良的耐化学腐蚀性、 耐油、 耐水、 耐海水、 耐热、 耐溶剂。
适用于通风不良的环境下施工, 如贮油罐、 船舶油水舱、 混凝土贮罐、 化学品贮槽及溶剂
贮罐等。
Not containing volatile organic solvent, the volume solids up to 100%, curing at room temperature 5-45℃
The film possesses excellent high adhesion, excellent mechanical properties and Easy application.
The paint possesses excellent resistance to chemical, oil water, seawater, heat and solvent.
Suited for application in poor untilation such as oil tank, oil-water carbine, concrete tank, chemicals tank and solvent tank etc.

Product
Description
产品简介
双组份, 施工前混合均匀, 甲组份为漆料, 乙组分为固化剂
Two components, component A is basic agent, and B is special curing agent, Stir till to even before application.

Product
Information
产品数据
Volume Solids 体积固体份
≥50%ccording   100%

Dry Film Thickness干膜厚度
The recommended is 200um,and also can adjust according to various
specification. 推荐为200um,根据不同使用要求调整

Theoretical Coverage 理论涂布率
3.9 m2 /Kg, at 200 um of DFT      以200微米干膜厚计

Practical  Coverage 实际涂布率
Allow appropriate loss           允许适量损耗

Application Details
施工详述

Mix Radio 混合比
4parts to 1part by weight     重量比 4: 1

Method of Application 施工方法
Airless Spray         无空气喷涂    Suitable for coating or repairing small area
                                 适用于小面积涂装或修补
Brush or Roller       涂刷或辊涂    Suitable for coating or repairing small area
                                 适用于小面积涂装或修补
                                    Total output pressure depends on application
Temperature and viscosity of paint
                                    总输出流体压力视施工温度和漆液粘度而调节
Conventional Spray   传统喷涂       Not recommend     不适用

Thinner                   稀释剂           Not necessary , If no effect to application ,may
                                           Use C003
不需要, 在不影响施工的情况下也可采用C003

Cleaner                  油漆设备清洗剂     C003

Pot Life                 使用期             25℃-1hour(小时)        

Induction period          熟化时间           After mixing component A and B, can be
                                            Used immediately without ripening.
                                            本产品甲、 乙组份混合后不需熟化, 能够马上使用

Storage                 贮存期                One year               一年

Drying time
干燥时间

Substrate
Temperature
底材温度,℃
Touch Dry
表干
( h)
Hard dry
硬干
(h)
Complete cure
  完全固化
   ( h)
Over coating Interval
覆涂间隔

Mix最短
Max最长

23
35
16
10
48
24
10 d
10 d
24 h
8 h
2months
1months

Storage and
Handling
贮存与管理
Storage         贮存            Store in cool fireproof conditions. The temperature of environment is
no more than 45℃         
贮存于凉爽干燥处, 防水, 防火, 环境温度不超过45℃不超过
Pack size     包装规格         A;16Kg in 20 liter container          甲:16公斤装于20公升容器中
                             B:4Kg in 4 liter container             乙:4公斤装于10公升容器中
Flash Point      闪点          65℃
Specific Gravity  比重         About 1.3 Kg/L                      约1.3公斤/公升
感谢 的支持!
来源: 江苏纽克莱涂料有限公司官网
Specification and
Surface preparation
技术要求及表面处理
The surface of steel should be prepared to Sa2.5 with shot blastubg. This paint on various shop primer and anti-corrosive primer。
未涂底漆的表面需经抛丸或喷砂处理达Sa2.5级, 可与各种车间底漆, 防锈底漆配套。

Limitations
        限制    

When applying must mix component A and B according to practical necessary quantity, the stir to even, use up within the pot life in case waste due to curing.
After coating this paint, load oil until the paint cures completely, Whether this paint is suitable to store other goods do not be approved by our company in advance
After coating this product, heating to 45-120℃ will decrease the drying time and increase
The performance of paint system.
使用本产品, 应现用现配, 用多少陪多少, 并充分搅拌均匀, 在使用期限内用完, 以免凝胶浪费,
涂装此涂料后, 须完全固化后, 方能装载油类等物品, 若需装载其它化学品, 请像本公司咨询, 涂装本产品后, 适当加温至( 45-120℃) 可缩短干燥时间, 提高漆膜性能。
The coat is resistant to the following chemicals: Please consult our company about other chemicals.
涂层可耐以下化学品:       未列化学品请向本公司咨询
原油        Crude oil             200#溶剂汽油     200# solvent-type gasoline
汽油        Gasoline             润滑油          Lubricating oil
柴油        Gas oil               
煤油      Carbon oil         化学污水( 含酸或碱及盐类) Chemical sewage( containing acid alkali or salts)
重油        Heavy oil          弱酸、 弱碱及大多数盐类 weak acid, weak alkali and must kinds of

 Safety
  Precautions
  安全措施
This product should be used in painting area by professional operators. When painting, please refer to Product Data Sheet and MSDS. Consult our company if consumers could not completely understand the precautions for safety and health when applying this product.
Although this paint product is free of solvent, minimal safety precautions, as follow, should be done in order to avoid danger or accident:
This paint is flammable, so must be far away from open flames.
In general this paint has no danger of explosion. However, enough ventilation is necessary at application site.
Because the paint liquid is harmful, protect Product skin and eyes, and avoid touching with paints (Recommend to wear working clothes, gloves, eye  protection, face  masks barrier cream and so on ). If paint gets in touch with skin, was fully with large amount of fresh water and soap or appropriate commercial cleaner. In case of eyes being contaminated, rinse with fresh water for 10min at least and give medical treatment immediately. Recommend face guard with ventilation pipe for the sake of no absorption of paint fog and harmful solvent gas, especially in bad ventilation.
Handle empty containers with care and do not bring about environmental contamination.
NOTICE: If consumers have not taken effective safety precautions (Refer to the specifications), our company will NOT be responsible for any accident.
   本产品由专业人缘在工业场所使用, 使用时请参照本说明书及健康安全手册, 如客户在使用本产品前, 未能仔细了解有关产品的健康安全知识, 请与本公司联系。
该涂料为无溶剂涂料, 为避免事故或危险发生, 应采取最低限度的安全措施如下:
该涂料为可燃物, 应远离明火。
一般情况下无爆炸危险, 但仍应适当通风以改进涂装环境。
采取有效措施以防止皮肤和眼睛与涂料接触(如使用工作服, 手套, 护目镜, 面罩及涂防护油等)如产品不慎接触到皮肤, 应用温水及肥皂或适当的工业清洁剂彻底清洗, 如眼睛受到污染, 用清水冲洗至少10分钟, 并立即就医。
建议佩戴通风面罩以避免吸入漆雾和有害溶剂气体,特别在通风不良环境下施工时,细心处理旧漆桶以免污染环境。
  责任声明: 对于未按本公司要求采取有效安全措施儿引起的安全事故,本公司不负任何责任。
来源: 江苏纽克莱涂料有限公司官网